![]() With V-Ray 6 it is possible to directly convert real-time scenes from Enscape and make them as photo realistic as possible. NEW in v6: V-Ray & Enscape compatibility.The library will take a lot of time but that's a long-term project then. I hope this time-issue can be resolved, that would be a great first step. (I even used to teach Vray 2.0 from time to time in architecture offices). I have a massive library of sketchup models with vray2.0 materials on them, ready to render, it's almost impossible to redo them all.ĭon't get me wrong, I'm a huge fan of Vray, I have been for many years now. Is there any way we can extend the use of 2.0 (I even want to pay for it) as right now I'm losing valuable time (and therefore losing income). That rendered in 12 minutes.Īlso, on the side, I can't find the parameter to reduce the burn value anymore? Where would that be found? Almost the same as the kitchen image I attached, that's bigger (2160x2160) and way more complex. I rendered at 1200x1200 pixels at quality "high". The only "complex" material is the floor, which is a standard material from the Vray Library. In 2.0 that would have taken 10 tot 15 minutes (without distributed rendering).Īs a test, I timed a render of a newly created skp file, with just a room, 1 opening for sunlight (no glass or window) 1 spotlight and 2 white blocks. I have now created 3 renders 1800by2250 pixels and they took 1,5 hours to render, each. So I would assume that that's not the cause either. I haven't imported any old visopt settings. I wasn't doing anything special what could have caused the crash. Sketchup crashed 3 times in about 2 hours as wel. Created in sketchup 2017, only with materials coming from Vray 3.4 and no old components imported. The issue does occur in brand new models as well.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |